Filter
Top Products
24
Speaker setup
After you have installed the DTR-6.2, connected all the components,
and determined the speaker layout, it is now time to perform the
settings in the Speaker Setup menu for the optimum sound acoustics
for your environment and speaker layout.
Before you perform the following settings, it is important that you
first determine the following characteristics:
• The types and sizes of the speakers that are connected.
• The distance from each speaker to your normal listening
position.
Before performing the settings, write down your speaker
settings in the diagram below for future reference.
Setup
Push To Enter
DSP
/
Mode ADJ
Speaker Configuration submenu
This submenu provides settings that tell the DTR-6.2 which speakers
you have connected and what size they are.
1. Press the Setup button.
If a menu other than “1. Speaker Setup”
appears, turn the jog dial until “1. Speaker
Setup” does appear.
2. Press the jog dial.
Push To Enter
DSP
/
Mode ADJ
3. Press the jog dial.
4. Turn the jog dial to set whether or
not a subwoofer is connected.
Yes: Select when a subwoofer is connected.
No: Select when a subwoofer is not
connected.
Push To Enter
DSP
/
Mode ADJ
SL SR
Front
a.
meters / feet
b. [ ]
m/ft
c. [ ]
m/ft
d. [ ]
m/ft
Front
SW Center
b c b
dd
Monitor
Your speaker settings:
Buttons to be used
Setup button:
Press to enter the main menu level and put the DTR-
6.2 in the mode for setting the various parameters. If
currently in the setting mode, press to exit.
Jog dial:
If the indicators directly above and below the jog dial
are lit, turning the jog dial selects a submenu and
pushing the jog dial enters the selected submenu (i.e.
takes you one level down).
If the indicators directly to the left and right of the jog
dial are lit, turning the jog dial changes the setting of
the currently selected parameter and pushing the jog
dial displays the next parameter.
Return button:
Press to go back one level up.
Use the buttons on the DTR-6.2 to navigate through the menus and
set the various settings and parameters according to your system
setup and layout.
Setup
Return
Push To Enter
DSP
/
Mode ADJ
Push To Enter
DSP
/
Mode ADJ
The normal order for performing the settings for speaker setup in
your DTR-6.2 is to set the speaker configuration settings first, set the
speaker distances second, and then calibrate the speaker levels third.
Below is an explanation of how to perform these settings using the
controls on the DTR-6.2.
You can also perform these settings using the On-Screen Display
(OSD) menu (see page 34).
The settings are in a hierarchical configuration as shown below.
Level 1 Main menu level
The level consisting of the menus contained in the Setup menu.
Level 2 Menu level
The level consisting of the submenus contained in each menu.
Level 3 Submenu level
The level consisting of the parameters contained in each submenu.
Standby/On
Standby
Power
On
O
f
f
Phones
Video 1
Video 3
DVD Video 2
Video 4
Audio
Selector
Bass
Treble
Master Volume
Smart
Scan
Navigator
Rec Out Zone 2 Zone 2 Level
CH Level
DimmerDisplay
Tuning
FM ModePreset Memory
Preset
VCR 1
VCR 2
Tape FM AM Phono CD
Push To Enter
DSP/Mode ADJ
Setup
Return
Setup
Return
Jog dial