Filter
Top Products
40
Setup menus
2-4. IntelliVolume sub-menu
Input source signal (display) Analog/PCM Source Digital Format
Type of media Tape, CD, DVD,
Record, Tuner Digital satellite broadcast,
DVD Video (PCM), LD (PCM) DTS-CD
Digital satellite broadcast Dolby Digital 2ch Source DTS,
All excluding
Listening Mode Dolby Digital 2ch
Direct ●
Stereo ●●●
Surround Pro Logic II (Movie) ●●
Pro Logic II (Music) ●●
Dolby Digital ●
DTS ●
Orchestra ●
Unplugged ●
Studio-Mix ●
TV Logic ●
All Ch Stereo ●
Relationship between input source and listening mode
Notes:
• The listening modes that can be set are different for each input source format.
• You may not be able to select all the listening modes shown here depending on your speaker
configuration or the selected input source.
a. IntelliVolume
When switching input sources, you may find that the output level for
different components or input sources connected to the DTR-6.2 is
different even though the main volume setting is the same. Under
normal circumstances, you would then have to change the volume
setting each time you change the input source. This IntelliVolume
sub-menu allows you to preset a volume level for each input source
separately so that when you do switch from one input source to
another, the DTR-6.2 adjusts the volume accordingly so that the
resulting volume stays the same. To set the IntelliVolume, simply
select an input source at the front panel, and if that source is quieter
than other sources, increase its decibel level with the
cursor
button, or if it is louder than other sources, decrease its decibel level
with the
cursor button.
The IntelliVolume can be adjusted between –12 and +12 decibels.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
2.Input Setup
Input:DVD
a.Audio Setup
b.Video Setup
c.Listening Mode Preset
d.Tone Control
e.IntelliVolume
f.12V Trigger
|ENTER| Quit:|OSD|
2-4.IntelliVolume
Input:DVD
a.IntelliVolume
: 0dB
Quit:|SETUP|
2-5. 12V trigger sub-menu
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
2.Input Setup
Input:DVD
a.Audio Setup
b.Video Setup
c.Listening Mode Preset
d.Tone Control
e.IntelliVolume
f.12V Trigger
|ENTER| QuSD|
2-5.12V Trigger
Input:DVD
a.12V Trigger A :On
b.12V Trigger B :Off
Quit:|SETUP|
This sub-menu allows you to make the required settings to turn on
the output from the 12V TRIGGER terminal to control another
component or device with the DTR-6.2 for each input source.
a. 12V Trigger A
On: Select to activate the device connected to the 12V TRIGGER A
terminal when the input source is selected.
Off: Select when no device is connected to the 12V TRIGGER A
terminal or you do not want the connected device to activate.
b. 12V Trigger B
On: Select to activate the device connected to the 12V TRIGGER B
terminal when the input source is selected.
Off: Select when no device is connected to the 12V TRIGGER B
terminal or you do not want the connected device to activate.