Filter
Top Products
PROGRAMMING
4-16
November 1998
Part No. 001-7600-001
The following screens selected in the preceding
Screen menu are unique to PMR models. Refer to on-
line help for information on parameters in these
screens.
Rx Code Channel - This screen is shown below and it
programs the receive 5-tone code information.
Tx Code Channel - This screen is shown below and it
programs the transmit 5-tone code information.
User Tone Format - This screen is shown below and
it programs special tone frequencies and the 5-tone
format information.
4.6 CLONING (PROGRAMMING ONE
TRANSCEIVER WITH ANOTHER)
One transceiver can be used to program another
with identical data. Replication Cable, Part No. 597-
2002-200 is required to connect the transceivers
together (see Table 1-1). The master (source) trans-
ceiver must have the following Common screen (see
Table 4-7) parameters programmed to perform
cloning:
•
Transmit Data Out = Enabled. If this parameter is
not enabled, the transceiver does not go into the
clone mode. The programming of this parameter
does not affect the ability to receive data. Therefore,
it can be in either mode in the slave (target)
transceiver.
•
Set Mode Access = Enabled. This must be pro-
grammed to allow the Dealer Set mode to be
accessed so that cloning can be enabled.
•
Dealer Passcode. This six-digit code must be
known to enable the Dealer Set mode.
Proceed as follows to program one transceiver
with another:
1. Select the Dealer Set mode in the Master (source)
transceiver by turning power on with the F1 and up
key pressed.
2. The display then indicates “DEALR” which is the
prompt to enter the six-digit Dealer Passcode. Enter
this code using the F1-F4 and down key. The
numbers represented by each key are as follows.
When the correct number is entered, “SETMODE is
displayed. If six digits have been entered and this is
not displayed, an incorrect number may have been
entered. Repeat starting with step 1. Refer to Section
3.3.2 for more information.
3. Press the F4 key to select the clone mode. The
display should indicate “CLONE”.
Key
Number
Entered
0
5
1
6
2
7
3
8
4
9
F
1
F
2
F
3
F
4