[] LISTENING TO THE RADIO
• Check that the remote control unit is set to AMP mode (TAPE, CDR/MD or CD).
1
2
Set the input function to "TUNER".
_ur_Tl°" _NBn
(Main unit} (Remote control unit}
B_IND
Watching the display, press the
BAND button to select the desired
band (AM or FM).
{Remote cohttoJ unit)
Mn0E Press the MODE button to set the
auto tuning mode.
{Remote contro_ unit)
"Auto" appears on the display.
4
{Remote c0_tloJ unit)
Press the TUNING + (up) or -
(down} button.
Automatic searching begins, then
stops when a station is tuned in.
If tuning does not stop at the desired station, use to the "Manual
tuning" operation.
1
(b 4
1 ¢
@e.e_@
®®ek
dooo
I
1
2
Set the input function to "TUNER".
{Main unit)
BAND
{Remote colltlol urfit)
MOBE
{Remote co_tro_ unit)
I_NBR
(Remote control unit}
Watching the display, press the
BAND button to select the desired
band (AM or FM).
Press the MODE button to set the
manual tuning mode.
Check that the display's "AUTO"
indicator turns off.
4
{Rem0te c0ntr01 unit)
Press the TUNING + (up) or - (down}
button to tune in the desired station.
The frequency changes continuously
when the button is held in.
NOTES:
• When in the auto tuning mode on the FM band, the "STEREO"
indicator lights on the display when a stereo broadcast is tuned in.
At open frequencies, the noise is muted and the "TUNED" and
"STEREO" indicators turn off.
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the "STEREO" indicator turns off.
61