Filter
Top Products
4
Select the mode.
Select "Auto" or "Manual".
• AUTO:
Adjust the level while Eistening to the test tones produced
autematicaEly from the different speakers.
• Manual:
Select the speaker from which you want to produce the test tone to
adjust the level.
Channel Level
i
,_Test Tone _4:_
Test Tone Start [)_<
Level Clear [i_4
Example: When the "Auto" mode is selected
Select "Test Tone Start".
Channel Level
Test Tone _4:_
_Test Tone Start [%_4
Level Clear [_4
7
a. if the "Auto" mode is selected:
Test tones are automaticaly emitted from the different speakers.
The test tones are emitted from the different speakers in the
following order, at 4-second intervals the first time and second dme
around, 2-second intervals the third time around and on:
._ I spkr
2spkrs
When the surround back speaker setdng is set to "lspkr" for
"Speaker Configuration", this is set to "SB".
b _ _ Use the CURSOR left and right buttons to adjust all the speakers to the
_,:t _ /r_]_ same volume.
\_/ "_4"_ The volume can be adjusted between -12 dB and +12 dB in units of
"% osdR
b. When the "Manual" mode is selected
Use the CURSOR up and down to select
the speaker for which you want to output
test tones, then use the CURSOR left and
right to adjust so that the volume of the
test tones from the various speakers is
the same.
Test Tone
_FL <-1 1. 5dB_
B C 0. 0dB
FR 0. 0da
SR 0. 0dB
SBR 0, 0dB
SBL 0. 0dB
Flashing SL 0. 0dB
SW 0. 0dB
Example: When the volume is set to-115 dB
while the test tone is being
produced from the Front Lch
speaker
Test Tone
EFFL <--11. 5dB)
B C 0, 0dB
FR 0. 0dB
SR 0. 0dB
SBR 0. 0dB
SBL 0. 0dB
Flashing SL 0. 0dB
SW 0, 0dB
Example:When the volume is set to -t 15 dB
while the Front Lch speaker _s
selected
_ After the above settings are completed, press the ENTER button.
%
The "Channel Level" screen reappears.
To cancel the settings, select "Level Clear" and "Yes" on the "Channel Level" screen, then make the settings again.
The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.
If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test
tone by ear is difficult, use a well known music selection and adjust for natural balance.
NOTE: When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control.
22