Denon AVR-2803/983 Home Theater System User Manual


 
Set the distance between the
center speaker and listening
position.
The distance changes in units of
1 foot (0.1 meters) each time the
button _s pressed. Select the
value closest to the measured
distance.
Delay Time
Default [_4
Front L 12ft
, Front R 12ft
,_Center <12ft_
Example:When the distanceis setto 12 feet
forthe centerspeaker
Delay Time
ETSL <10ft_
SR 1Oft
SBL 1Oft
SBR 1Oft
If "Yes" is selected for "Default", the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be
20 ft (6.0 m} or less. If you set an invalid distance, a CAUTION notice,
such as screen right will appear. In this case, please relocate the blinking
speaker(s) so that its distance is no larger than the value shown in
highlighted line.
Default [_4
Front L 12ft
Front R 12ft
Center lft
B'_111tfl DNilI!
__\ Enter the setting.
The System Setup Menu reappears.
The AVR-2803/983 automatically sets the optimum surround delay time for the listening room.
NOTE:
If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16, 17}.
Use this setting to adjust so that the playback level between the different channels is equal.
From the listening position, listen to the test tones produced from the speakers to adjust the level.
The level can also be adjusted directly from the remote control unit. (For details, see page 49.)
1
At the System Setup Menu select "Channel Level".
System Setup Menu
Speaker Configuration
Delay Time
_Channe I Level
Digital In Assignment
Video In Assignment
Dolby DiKital Setul0
Zone2 Control
Switch to the Channel Level screen.
Channel Level
_Test Tone _4:_
Test Tone Start [_<
Level Clear [_4
Select "Test Tone".
21