Denon AVR-2803/983 Home Theater System User Manual


 
[] SETTING UP THE SYSTEM
Once all connections with other AV components have been completed as described in "CONNECTIONS" (see pages 6 to 13), make the various
settings described below on the monitor screen using the AVR-2803/983'S on-screen display function.
These settings are required to set up the listening room's AV system centered around the AVR-2803/983.
Check that the remote control unit is set to AMP mode {TAPE, CDR/MD or CD).
The system settings can be reset to the default {factory shipment) settings by initialization of the microprocessor (see page 63).
Use the following buttons to set up the system:
_s SETU P button
to display the system setup menu.
t
R buttons 1
Use these to move the cursors (< and I_) to the left I
and right on the screen. /
: Use these to move the cursors (A and ,} to the upl
and down on the screen. |
ENTER button
Press this to switch the display.
A so use th s button to compete the setting.
I
System setup items and default values {set upon shipment from the factory)
Speaker
Configuration
Crossover
Ftequency
Su#w0ofe rr0de
Delay %me
Channel
Level
Digital _n
Assignment
System setup
Input the combination of speakers in your system and their
corresponding sizes {Small for regular speakers, Lalge for full size,
fu_] range) to auton,aticaHy set tile composltion of the slgnals output
from the speakers and the frequency response
Set the frequency (Hz) below which the bass sound of the vanous
speakers is to be output from the subwooter
This selects the subwoofer speaker for playing deep bass signals
This parameter is for optimizing the timing with which the audio
slgna_s are produced from the speakers and subwoofer accotding to
the listening position
This adiust s the volume of the signals output from the speakers and
subwoofer for the different channels irl order to obtain optimum
effects
This assigns the color difference (component) video input jacks for
the different input sources
Turn the audio compression on or off when down mixing Dolby
Digital signals
Power AMP
Assignment
Zone2
vol Level
Set the Ext In Subwoofer terminal p_ayback level
Set the Auto surround mode function
This sets whether or not to display the on_creen display that
appea_s on the monito¢ screen when the controls on the remote
control unit or main unit are operated¸
Set the Trigger Out output for the different input sources
Front Sp
Large
Front L & R
12 It (36 m)
Front L Front
OdB 0dB
CD I DVD
COAX1 I COAX2
I
DVD I VDP
VIDEO1 I NONE
Center Sp
Smal_
Default settings
Sub Woofer Surround Sp
Yes Small
80 Hz
LFE
Surround L & R
/0 ft (3Ore)
OFF
Surlouiid Back
Variable
Subwoofer +lSdB
Auto Surround Mode = ON
On Screen Display ON
Surround Back Sp
Small / 2spkls
SBL & SBR
10 ft {3 0 ml
i_/und SubwooferOdB
VCR 2 TAPE
OFF OPT4
16