Denon AVR-2803/983 Home Theater System User Manual


 
Select the play mode.
Example: Stereo
8UF_JND SELECT
MODE _O _
(Main unit)
_E_O
(Remote control unit)
To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the
surround mode button then operate the selector.
SURROUND
MO_E
{Mainunit)
Start playback on the selected component.
For operating instructions, refer to the component's
manual.
Adjust the volume.
The_elis
d_splayed on the
master volume _evel
display
(Main unit) (Remote control unit)
'_ The volume can be adjusted within the range of -80 to 0 to 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
descnbed on page 21 or pages 49 and 50, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. {In this case the maximum volume adjustment range
is "18 dB -- {Maximum value of channel level)".}
Input mode when playing DTS sources
Noise will be output if DTS compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL}
and set the input mode to "DTS'.
Input mode display
in the AUTO mode
INPUT
_UT9 PCM _TS
@ o @
/i k
in the DIGITAL PCM mode
_NPUT
AUTO \p_ OTS
o o o
in the DIGITAL DTS mode
_NPUT
AUTO PCM _TS_
o o o
_1 k
in the ANALOG mode
INPUT
AUTO pCM DTS
o o o
One of these Hghts, depending on the
input slgna_
Input signal display
DOLBY DIGITAL
O
DTS
D GITA_0 C
PCM
0 0
The _ indicator lights when digital signals are being input
properly. If the _ indicator does not light, check whether
the digital input component setup {page 23) and connections are
correct and whether the component's power is turned on.
NOTE:
The _ indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
43