• This setting assigns the color difference (component} video input jacks of the AVR-2803/983 for the different input sources.
1
At the System Setup Menu select "Video In Assignment".
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
zVideo In Assignment
Dolby Digital Setup
Zone2 Control
2
Switch to the Video In Assignment screen.
Video In Assignment
[_: NONE
[_: NONE
[_: VIDEO2
_: NONE
_: NONE
[_: NONE
Default [_4
Select the component (Y, PB/C8 and PR/CR)video input terminal to be assigned to the input source.
(_ input source selection _ _2_Component video terminal selection
Select "NONE" for sources for which the component (Y, PB/C8 and P£/C£) video input is not to be used.
-_ When the default, "Yes", is selected, the settings are reset to the factory defaults.
4 ENTER the setting.
The System Setup Menu reappears.
Sets the down-mixing method when not using a center speaker or surround speakers.
OFF: The dynamic range is not compressed.
ON: The dynamic range is compressed automatically according to the combination of speakers being used.
1
2
At the System Setup Menu select "Dolby Digital
Setup" and press the ENTER button.
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
Video In Assignment
zDolby Digital Setup
Zone2 Control
Select "ON" if you want to use the Compression, "OFF" if you do not
want to use it.
NOTE:
When not using a center speaker or surround speakers, the sound is
played from the front speakers. If the sound should seem distorted
because the input level exceeds the allowable input for the front
speakers, set "Compression" to "ON".
Dolby Digital
Downmix Option Setup
Compression
24