Filter
Top Products
Service Mode
10-5
5975338 BARCOVISION 9200 210497
Modify password
To change your password, highlight
'Modify password'
and press
ENTER to start up the password modification procedure.
Enter your old password with the digit keys. After the fourth digit is
entered, the next modify password menu is displayed.
Enter Old Password :
----
MODIFY PASSWORD
Your new password will be asked if your old password is correct.
Enter your new password with the digit keys. After the fourth digit, the
projector will ask to re-enter your new password.
Enter New Password :
----
MODIFY PASSWORD
Re-enter New Password :
----
MODIFY PASSWORD
Re-enter your new password .
When the password is correct, the message "Password modified" will
be displayed for a certain time and then the projector returns to the
Service menu.
When the password is not correct, an error message "Invalid pass-
word" will be displayed. Press EXIT to continue. The projector
returns to the Service menu without changing the password.
Lamp Run Time History
To get an overview of the different lamp run times, highlight
Lamp
Run time History
with the joy stick and press ENTER. A listing with the
lamp serial number and the corresponding run time will be displayed.
SERVICE MODE
878c
Modify Password
Reset Lamp Run Time
Lamp Run Time History
Convergence
Display Settings
Decoder Settings
Color Balance
I2C Device Test
LAMP RUN TIME HISTORY
> SN1425634 75 h
SN1234567 1000 h
SN0000000 0 h
SN0000000 0 h
SN0000000 0 h
SN0000000 0 h
SERVICE MODE
878b
Modify Password
Reset Lamp Run Time
Lamp Run Time History
Convergence
Display Settings
Decoder Settings
Color Balance
I2C Device Test
Reset Lamp Run Time.
Highlight
Reset Lamp Run Time
with the control disk and press
ENTER to select.