Filter
Top Products
Picture Control in Adjustment Mode
9-2 5975338 BARCOVISION 9200 210497
Gain adjustment per color
If the obtained color balance is not yet correct, adjust with the
separate gain controls until the desired color balance is obtained.
Smoothness
The lower the smoothness value, the sharper the image. The
influence of this setting is visible on high density image with small
characters.
Still video [On/Off]
This function is only used for stationary interlaced images.
Highlight Still Video by pushing the control disk up or down and press
ENTER to toggle between ON and OFF.
Still Video [On] : the displayed image contains less jitter and gives a
sharper image.
Still Video [Off] : for moving pictures.
Sync [Fast/Slow]
Highlight Sync by pushing the control disk up or down and press
ENTER to toggle between Slow and Fast.
Note : Sync is normally used in the SLOW position. The FAST
position is used to compensate for unsteady sync pulses from older
video playback equipment.
Color Balance
Highlight Color Balance by pushing the control disk up or down and
press
ENTER to select the color balance selection menu.
The next choices are possible :
3200K
6500K
9500K
Custom
Use the control disk to make your selection and press
ENTER.
A marker indicates the actual color balance setting.
SIGNAL OPERATIONS
Video offset 100
Gain
Gain red 200
Gain green 200
Gain blue 200
Gamma 1.0
Smoothness 4
Still Video [Off]
Sync [Slow]
Color balance
859
3200
6500
9500
Custom
G
B
R
Tc = custom
1.03
1.01
When custom is selected, the blue and red color can be adjusted
(range from 0 to 2.5) in comparison with the green color (value 1).
Push the control disk up or down to select blue or red. Push the
control disk to the left or to the right to adjust.