Filter
Top Products
Connections
6-8 5975338 BARCOVISION 9200 280497
Loosen the locking Open the top cover
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 H z
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAGNOSTICS
CODE
IR-RECEIVER
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This de vice co mplie s w it h Par t 1 5 of the FC C ru le s. O per a tio n
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAG NOST ICS
CODE
IR-RECEIVER
Processor module
1
3
2
S2
S1
Baud rate switches
Change the position of the DIP switches with a small screwdriver.
If all switches are in the correct position, close the top cover and
secure it by turning the lock screw clockwise. Connect the power
cord to the wall outlet and switch on the projector.
Baud rate setting
baud rate S2/1 S2/2 S2/3
9600 OFF OFF OFF
4800 ON OFF OFF
2400 OFF ON OFF
1200 ON ON OFF
600 OFF OFF ON
300 ON OFF ON
150 OFF ON ON
75 ON ON ON
Connecting a RCVDS 05 to the projector.
- Up to 10 inputs (20 when video inputs) with the RCVDS 05 and 90
inputs when RCVDS's are linked via the expansion module.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector
(source selection and analog settings).
- The selected source number will be displayed on a 2 digit display
and the selected input module will be indicated with a LED on the
rear.
For more information about the use of the RCVDS 05, consult the
owner's manual, order number : R5975765.
Connecting a VS05 to the projector
The VS05 can switch up to 5 Composite Video sources, 3 Super
Video sources and 1 RGB analog or component video source to the
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order number : R9827890
For more information about the use of the VS05, consult the VS05
owner's manual, BARCO order number : R5975245.
Connecting an IR Remote Receiver 800 to the
projector.
This infrared red receiver unit makes it possible to control the
projector from another room.
There is a communication line cable between the IR receiver and the
projector or the RCVDS. The control information from the RCU can
now be sent to the IR Remote Receiver 800.
The IR Remote Receiver 800 displays the selected source on a 7-
segment display.
Order number : R9827515.
Screen
Communication cable
Projector
IR Remote Receiver 800
Projection room
Control room