Filter
Top Products
Location and Functions of Control
4-2 5975338 BARCOVISION 9200 210497
b. Remote control
This remote control includes a battery powered infrared (IR) transmit-
ter that allows the user to control the projector remotely.
This remote control is used for source selection, control, adaptation
and set up. It includes automatic storing of :
- picture controls (Brightness, Sharpness...)
- settings
Other functions of the remote control are :
- switching between standby and operational mode.
- switching to "pause" (blanked picture, full power for immediate
restarting)
- direct access to all connected sources.
- variable adjustment speed : when pushing continuously on the
control stick or the picture keys, the adjustment will be executed
in an accelerated fashion.
-
+
-
+
-
+
-
+
-
+
0
9
7
8
6
5
43
2
1
ENTER
14
13
12
9
8
1
2
3
4
5
7
15
32a
PAUSE
-
+
PHASE
FREEZ
10
11
TEXT
EXIT
ADJ
STBY
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
HELP
?
6
COLOR
PHASE
SHARPN
TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
2
1
4
3
5
6
8
0
9
7
CONTRAST
7
9
8
10
5
12
13
14
4
15
Remote Control (RCU)
Local keypad
Terminology
Back light key : when activated, all keys will be lighted up
and visible in the dark.
ADJ. : ADJUST key, used to display on line help while in the
adjustment mode.
Address key (sunk key), to enter the address of the projector
(between 0 and 9). Press the sunk address key with a pencil,
followed by pressing one digit button between 0 and 9.
STBY : stand by button - to start projection when the
power switch is switched on.
- to switch off the projector
without switching off the power switch.
PAUSE : to stop projection for a short time, press 'PAUSE'.
The image disappears but full power is retained for immedi-
ate restarting.
Help : on line help information
Digit buttons : direct input selection.
Picture controls : use these buttons to obtain the desired
picture analog level (see also 'Controlling').
PHASE : used to remove the instability of the image.
TEXT : when adjusting one of the image, e.g. controls during
a meeting, the displayed bar scale can be removed by
1
2
3
4
5
6
7
8
9
10
pressing 'TEXT' key first. To re-display the bar scale on the
screen, press 'TEXT' key again. 'TEXT' key only active in
operational mode.
FREEZ : press to freeze the projected image.
ENTER : to start up the adjustment mode or to confirm an
adjustment or selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards
when in the adjustment mode.
Control disk (on RCU) or '+' and '-' keys (cursor keys): to
make menu selections when in the adjustment mode.
The control disk can move forward, backward, to the right or
to the left.
Comparision between control stick movement and the use of
the cursor keys on the local keypad :
RCU = local keypad
control disk up = '+' key up
control disk down = '-' key down
control disk to the right = '+' key right
control disk to the left = '-' key left
Use the '+' and '-' keys (cursor keys) : to increase or decrease
the analog level of the image controls when they are first
selected.
RC operating indication : lights up when a button on the
remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
11
12
13
14
15