Filter
Top Products
Source Set Up
8-4 5975338 BARCOVISION 9200 210497
Vertical refresh [sync/async]
: The way of updating the image
information on the LCD panels.
* For sources with a vertical frequency up to 60 Hz : the vertical
refresh rate is the same as the vertical frequency of the incoming
source. This is a necessity to project moving images without 'motion
artefacts'. For stationary images with a vertical frequency up to 60 Hz
it is still possible to use asynchronous refresh. When loading Pal,
Secam, NTSC-files syncronous mode is default, for all other sources
below 60 Hz asyncronous mode is default.
* For sources with a vertical frequency higher that 60 Hz : the vertical
refresh is different than the vertical frequency of the incoming source.
Synchronous refresh cannot be used.
Vertical sync polarity
: Vertical refresh can be synchronised with the
leading sync edge [arrow down] or trailing sync edge [arrow up].
Press
EXIT to leave the Edit File Option menu.
Press
EXIT to leave the Edit menu. A confirmation menu will be
displayed (only when the file is opened as "Read/Write").
"Save changes to file "filename.ext" ?
yes or no.
Use the control disk to select yes or no and press
ENTER.
Rename
To change the name of a selected file to the name given in the TO
area.
Use the control disk to select RENAME and press
ENTER. The
rename menu will be displayed.
Use the control disk to select a file name in the left part of the menu
and press
ENTER to select. This file name will be written in the FROM
area and the TO area. The TO area is active.
Press
ENTER to select the separate characters. Push the control
disk to the right or to the left to select the desired character. Change
that characters by pushing the control disk up or down. Numeric
characters can be entered directly with numeric keys on the RCU.
Press
ENTER to select Ok.
Press
ENTER for OK. The renamed file is entered in the list of files.
Press EXIT to leave the Rename menu.
Copy
To copy a selected file to the file with the name and extension given
in the TO area.
Use the control disk to select COPY and press
ENTER. The copy
menu will be displayed.
Use the control disk to select a file in the list of files in the left part of
the menu and press
ENTER to select. This file name will be written
in the FROM area and the base name of the selected file in the TO
area. The file index in the TO area will be an unused file index. The
TO area becomes active. Press
ENTER to select the separate
characters. Push the control disk to the right or to the left to select the
desired character. Change that character by pushing the control disk
up or down (digits can be entered directly using the numeric keys).
Press
ENTER to select Ok.
Press
ENTER for OK. The copied file is entered in the list of files.
Press
EXIT to leave the Copy menu (note : if the file index is changed
to an existing index, a confirmation menu will be displayed).
FILE SERVICE
847e
Load
Edit
Rename
Copy
Move
Delete
Options
COPY FILE
pal .s1
pal .c50
secam .s3
853
pal .c50
From :
......... c..
To
......... c..
OK
FILE SERVICE
847d
Load
Edit
Rename
Copy
Move
Delete
Options
RENAME FILE
pal .s1
pal .c50
secam .s3
852
pal .c50
From :
......... c..
To
......... c..
OK