Filter
Top Products
Controlling
7-4 5975338 BARCOVISION 9200 280497
How to get a summary of your projector?
The Summary gives an overview of :
- type of projector
- soft version
- lamp run time
- projector run time
- address
- installation configuration
- baud rate
- projector serial number
- lamp serial number
To display the Summary on the screen, press
ENTER to start up the
Main
menu. Push the control disk up or down to highlight
System
Settings
and press ENTER to display the
System Settings
menu.
Push the control disk up or down to highlight
Summary
and press
ENTER. The summary will be displayed on the screen.
The following information is displayed :
-
type
of projector : BARCOVISION 9200
-
software version
-
Address
: to change the address of the projector, see Projector
Address above in this chapter.
-
Installation
: possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in
chapter Installation Set Up.
-
Baud rate
: transfer speed for communication with a IBM PC (or
compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is
a difference, consult Set up of the baud rate for communication with
a computer in chapter Connections.
-
Projector Run Time
: gives the total run time since the first start up.
All projectors leave the factory with a run time of approximately 24
hours.
-
lamp run time
: the total time the lamp has been used since it was
installed in the projector.
Attention : the total lifetime of the lamp for a safe operation is 1000
hours maximum. Do not use it longer. Always replace the lamp with
an original BARCO lamp kit.
-
Projector Serial number
: indicates the fabrication number of the
projector. This number can be useful when calling for technical
assistance.
-
Lamp Serial number
: indicates the fabrication number of the lamp.
This number can be useful when calling for technical assistance.
MAIN MENU
832b
Picture Control
Audio Control
System Settings
File service
Service Mode
SYSTEM SETTINGS
Lamp Control: 1500W
Installation
Input slots
Summary
Color
SUMMARY
Type : BARCOVISION 9200
Soft version : 1.00
Address : 1
Installation : front/ table
Baudrate : 9600
Projector run time : 104 h
Lamp run Time : 104 h
Projector Serial Number : 1012123
Lamp Serial Number : 0111111