Wolf DCX-1500FD Home Theater System User Manual


  Open as PDF
of 152
 
Wolf Cinema Owner's Manual
4-2
Section4►Maintenance
Lamp: The projector uses a Cermax® Xenon lamp to deliver its high brightness. A lamp should
be replaced when it has reached its end of life or if a noticeable change in brightness occurs.
Keep track of the number of hours the lamp has been in use (Lamp Menu) and be aware of
any changes to brightness. These indicators will help you effectively maintain operation of the
projector.
WARNING
Wait approximately ve minutes after powering down the projector to allow
internal cooling fans to stop and for the lamp to cool sufciently before
removing.
Never attempt to remove the lamp housing directly after use. The lamp is under
great pressure when hot and may explode, causing personal injury and/or
property damage. Allow cooling completely.
WARNING
Use only lamps supplied by Wolf Cinema.
Use lamps of the correct wattage for your projector model when replacing.
Filter: Replacethelterwhenyoureplacethelamporsoonerifrequired.Itisimportantthelter
bereplacedregularlytoensuresufcientairowthroughtheprojector,otherwiseitcouldcause
the projector to overheat.
WARNING
Use only lters supplied by Wolf Cinema.
Refer to 4.4 Lamp and Filter Replacement for instructions.
The North American rated power cord is provided with each projector. Ensure that
you are using a power cord, socket and power plug that meets the appropriate local
rating standards.
Use only the attachments and/or accessories recommended by Wolf Cinema.
Useofothersmayresultintheriskofre,shockorpersonalinjury.
WARNING
Use only an AC power cord recommended by Wolf Cinema.
Do not attempt operation if the AC supply and cord are not within the specied
voltage and power range.
Do not set or rest items on the power cord. Place the projector in an area where the projector •
cord cannot be abused or damaged by persons walking on it or by objects rolling over it.
Operate the projectorat the specied voltage only. Do notoverload power outlets and•
extensioncordsasthiscanresultinreorshockhazards.
The projector is equipped with a three-wire plug having a third grounding pin. This is a safety •
feature – if you are unable to insert the plug into an outlet contact an electrician to have the
outlet replaced. Do not defeat the safety purpose of this grounding-type plug.
Lamp >
Power Cord and >
Attachments
 previous next