Filter
Top Products
Wolf Cinema Owner's Manual
2-18
The GPIO connector on the input panel can be used to provide a method of interfacing a wide
range of external I/O devices to the projector.
Refer to Appendix E: System Integration for complete details on pin conguration and how to
program the various pins on the connector.
The North American rated power cord is provided with each projector. Ensure that
you are using a power cord, socket and power plug that meets the appropriate local
rating standards.
Plug the power cord to the AC receptacle located at the back of the projector, below the input
panel, and the three-pronged end into a grounded AC outlet. Ensure the socket outlet is installed
near the equipment and is easily accessible. The input voltage to the projector must be capable
of 100 – 240 VAC in 500W and 1000W models and 200-240VAC in 1200W models. (See also
Section 6 – Specications for complete details on all power requirements.)
Use the approved North American-rated power cord supplied with the projector. If you are
connecting to an area outside of North America ensure an appropriately power cord rated for the
region of use is used.
Always power down the projector before unplugging the AC power cord. Wait 5-10 minutes
forthemainexhaustfantoturnoffandforthelamptocoolsufcientlybeforeunpluggingthe
projector.
WARNING
Do not attempt operation if the AC supply and cord are not
within the specied voltage and power range.
Wait for the cooling fans to turn off before unplugging the projector.
Section2►InstallationandSetup
2.5 System Integration
- GPIO Connector
2.6 Power Connector