Filter
Top Products
Wolf Cinema Owner's Manual
2-11
Mounting
There are several methods for mounting the projector. Depending on your chosen installation,
one method may be more suitable than another. In typical front and rear screen installations the
projector can be mounted to a secure and level surface, such as a table.
CEILING MOUNT — The projector can also be inverted and suspended from the ceiling using
a specially designedceiling mount xture. Thistype of mounting isrecommended for xed
installations and for those that want the projector out of sight or have a limited space for projector
and audience.
Use only the WOLF CINEMA approved ceiling mount kit designed for your projector.
Refer to the installation instructions and safety guidelines provided in the kit.
SPECIAL MOUNTING — The projector can be rotated (front-to-back) up to 360 degrees and
mounted without it affecting performance. However, the side-to-side tilt limit of the projector must
not exceed ±15 degrees. This tilt limit is required to ensure optimal performance of the lamp.
(Figure 2.5.)
Adjusting projector height
You can modify the height of the projector to remedy a slightly unlevel mounting surface by
adjusting the two feet threaded into the front bottom chassis. Turn each foot clock-wise or
counterclockwise until the project is level on all sides.
Folded Optics
In rear screen applications where space behind the projector is limited, a mirror may be used to
fold the optical path. See Figure 2.7. The position of the projector and mirror must be accurately
set — if considering this type of installation call your dealer for assistance.
Section2►InstallationandSetup
Figure 2.5 Folded Optical Path
Iso - Rear Left View
Iso - Front Right View
Rear View
Top View
Side - Left View
Side - Right View