Filter
Top Products
Trigger Level
To set the trigger level, use hpe1432_setTriggerMode to select “level” or “bound”
mode; and use hpe1432_setTriggerLevel twice to set both the upper and lower
trigger levels. The difference between the upper and lower trigger levels must be
at least 10% of full scale (and 10% is usually the best amount).
Also use hpe1432setTriggerSlope to specify a positive or negative trigger slope.
Level mode
If the mode is set to “level” and the trigger slope is positive, then the module
triggers when the signal crosses both the upper and lower trigger levels in the
positive direction. If the trigger slope is negative, the module triggers when the
signal crosses both levels in the negative direction. Setting two trigger levels
prevents the module from triggering repeatedly when a noisy signal crosses the
trigger level.
Bound mode
If the mode is set to “bound” and the trigger slope is positive, then the module
triggers when the signal exits the zone between the upper and lower trigger levels
in either direction. If the trigger slope is negative, the module triggers when the
signal enters the zone between the upper and lower trigger levels.
VT1433B User's Guide
Using the VT1433B
3-31