Filter
Top Products
To install the HP-UX VXIplug&play drivers for the VT1433B
(for HP-UX systems)
1 Log in as root.
2 Insert the VT1432A CD-ROM into the CD-ROM drive or obtain the latest VT1432A
distribution.
3 Type swinstall.
See the HP-UX Reference manual for information on the swinstall command.
The VT1432A distribution is normally installed in the /opt/vxipnp/hpe1432/
directory. The files have extensions such as .h, .fp, .sl and .hlp.
The Resource Manager
The Resource Manager is a program from the hardware interface manufacturer. It
looks at the VXI mainframe to determine what modules are installed. It is
necessary to run it every time the mainframe is powered up. If the “No VT1433B
can be found in this system” is found, then run the Resource Manager.
Before running the VT1432A/33B software make sure that the hardware is
configured correctly and that the Resource Manager runs successfully. Before
using the measurement system, all of its devices must be set up, including setting
their addresses and local bus locations. No two devices can have the same
address. Usually addresses 0 and 1 are taken by the Resource Manager and are
not available.
For more information about the Resource Manager, see the hardware interface’s
documentation.
VT1433B User's Guide
Getting Started With the VT1433B
2-6