Filter
Top Products
Operating Information
CSA 803A Service Manual
2Ć3
With the ON/STANDBY switch set to STANDBY, place the sampling head in a
compartment and slowly push it in with firm pressure. Once the sampling
head is seated, turn the lockĆdown screw to tighten the sampling head in
place.
CAUTION
Never install or remove a sampling head when the ON/STANDBY
switch is ON.
To remove the sampling head, set the ON/STANDBY switch to STANDBY.
Turn the lockĆdown screw to loosen the sampling head, and then slowly pull
out the sampling head.