Filter
Top Products
43Tact Audio
Step V:
Restoring the Default
RCS2.2X Settings
This step is optional and is only required if you would like to reset all
internal settings in the unit to their factory defaults. If you proceed
you will erase your custom user settings.
Restore the default settings for the new firmware installed on the RCS-2.2 X.
1 - From the TacT-2.2 X RCS software main screen, click on the “Options” menu
selection at the top of the screen and then select the “Default Settings” option.
You should now see the Default Settings window.
NOTE: If you have TacT digital amplifiers attached to the RCS-2.2 X you
must set the “AMP” front panel general menu to “DISABLED”. The default
settings will not be programed if these parameters are set to “ENABLED”.
2 - Select the “Default” button and the default parameters for the RCS 2.2 X will be
loaded into the RCS 2.2X. The RCS 2.2X will turn OFF and then ON and return to
normal operation when finnished.
You have now completed updating your RCS 2.2X and it is ready for normal
operation.
RCS 2.2X
update complete