Filter
Top Products
25Tact Audio
OPTIONS menu
The options menu allows for control of the systems maximum signal level, signal
detection threshold (SDTH), wheel speed, and remote control. To select an option
highlight it using the “UP” and “DOWN” navigational buttons. To modify a selected
option use the “LEFT” and “RIGHT” buttons.
- Max Level - This option controls the systems maximum signal
level. For example, if this option is set to -3.0 dB, the volume
control can not go above -3.0 dB.
- Detection - This option sets the signal detection threshold. If the
absolute value of the Left or the Right channel signal goes above
this threshold the red signaling dot will be displayed on the front
panel bellow the master volume display. This feature can be used
to indicate signal presence on either channel or to indicate near
clip condition. To use it as a signal presence indicator set the
Detection to a value close to -90.0 dB. To use it as near clip
indicator set the Detection to a value close to 0.0 dB.
NOTE: This light does not indicate clip condition.
- Wheel - This option sets the wheel sensitivity. The wheel
sensitivity can be set to between 1 and 10 or to “OFF” to
disable the Wheel for volume control. The lower the setting the
slower the volume increases and the higher the setting the faster
the volume increases with each turn of the Wheel.
- Remote - This option enables and disables the remote control.
Once the remote control is disabled the unit can only be con
trolled from the front pane
l.
Front Panel Display