Filter
Top Products
17Tact Audio
1 - STANDBY
The STANDBY button will turn the RCS 2.2X on or it will place it into standby
mode. When in stand by mode, the unit is placed into a low power “idling” state.
The standby button is also used to save changes that were made in the menu
parameters. By placing the unit into standby mode the current menu settings are
saved.
2 - DIGITAL
The DIGITAL button will scroll sequentially, allowing the selection one of the 5
digital inputs.
3 - ANALOG
The ANALOG button will scroll sequentially, allowing the selection one of the4
analog inputs.
4 - CORRECTION block
The CORRECTION block consists of 10 buttons. The buttons are numbered from 1
to 9 and one BYPASS. Pressing the BYPASS button will place room correction
into bypass mode – no correction. Pressing any of the remaining nine buttons will
engage the corresponding room correction preset.
5 - MENU
The MENU button will switch the front panel display from the status screen to the
main menu screen.
6. VIDEO
The VIDEO button is inactive with this unit.
7. UP
The UP navigational button is used to select menu options and/or change their
values.
8. DOWN
The DOWN navigational button is used to select menu options and/or change their
values.
9. LEFT
The LEFT navigational button is used to select menu options and/or change their
values.
10. RIGHT
The RIGHT navigational button is used to select menu options and/or change their
values.
11. ENTER
The ENTER button will select the menu option currently marked by the blinking
cursor or enter an edited parameter.
12. VOLUME Block
The VOLUME block consists of three buttons.
The “MUTE” button will mute/un-mute all enabled channels.
The “UP” button will increase the master volume level
The “DOWN” button will decrease the master volume level.
Remote Control