Filter
Top Products
27Tact Audio
The correction menu allows for control of all the room correction parameters. To
highlight an option use the navigation buttons and select it by pressing the
“ENTER” button.
1 - LEVELS , DELAYS and NAMES are menu options. To enter
one of these menu options highlight it using the navigation
buttons and then press the “ENTER” button to select it.
2 - CORR - This option allows for correction selection. When this
option is highlighted use the “LEFT” and “RIGHT” navigation
buttons to scroll through all possible correction presets. To
select the displayed preset press the “ENTER” button. Note
that the “*” character indicates the currently selected
correction preset.
3 - LOCK - This option allows you to lock the correction preset
setting. When this option is highlighted use the “ENTER”
button to toggle between the “YES” and “NO” options. When
“YES” is displayed the selected room correction preset is
locked and can not be changed by either front panel or remote
control.
4 - Active Corr. - This displays the currently selected room
correction preset number.
4 - Name - This displays the currently selected room correction
symbolic name.
NOTE: When a TacT digital amplifier is controlled by the RCS 2.2X, all of
the amplifiers front panel and IR controls are disabled. Use the RS232 port
and/or daisy chain to link the components.
CAUTION: The AMP setting should only be set to ENABLED if you have Tact
amplifiers connected to the RCS 2.2X. When the AMP option set to ENABLED
both the analog and digital output with will output a full level signal regard-
less of the RCS 2.2X master volume setting. If you do not have Tact amplifiers
connected to your system you will not be able to control the output level
from the RCS 2.2X volume control. The output is sent at its maximum level
and can result in damage to your speakers.
CORR menu
Front Panel Display