Filter
Top Products
15Tact Audio
Front panel controls
Standby
Use the “STANDBY” button to toggle between Standby mode and ON.
The display will indicate Standby mode by displaying a small green light in the left
side of the display. When the unit is placed in Standby mode all user settings are
saved.
Master volume
The master volume is controlled by turning the “TacT wheel”. The green digits on the
left side will change as you turn the wheel - this is your master volume level indicator.
(The wheel sensitivity, max. volume etc. can be set in the “OPTIONS” menu.)
Mute
Use the “MUTE” button to mute or un-mute during playback. The volume level indica-
tor will switch to “--” in Mute mode. You can still adjust the master volume while the
unit is in Mute mode - the volume level indicator will briefly indicate the level, then
switch back to the “--” mute indicator
Digital
input selector
Analog
input selector
Press the “DIGITAL” button to select the digital input. This is a toggle switch, and by
pressing it multiple times it will toggle through all of the five digital inputs. The se-
lected input will be displayed in the input display portion of the display.
Press the “ANALOG” button to select the analog input. This is a toggle switch, and
by pressing it multiple times it will toggle through all of the four analog inputs. The
selected input will be displayed in the input display portion of the display.
Navigation/Enter
Use the navigational buttons to navigate the options and select with the middle “En-
ter” button .
The front panel controls on the RCS 2.2X will allow you to access and control all
menu settings.
NOTE: The remote and front panel controls are disabled whenever a Per-
sonal Computer is connected and the Room Correction or ParEQ software is
running. To enable the remote and front panel controls press the “DIGITAL”
and “ANALOG” input selector simultaneously.
Standby
Mute
Analog Input Selector
Input Display
Digital Input Selector
Master Volume
Volume Level
Navigation/Enter
Menu
NOTE: Please note that the optional ADC module is required for analog in-
puts.
Press the “MENU” button to access the front panel menu system.
Menu