Filter
Top Products
CAUTIONCAUTION
40 Tact Audio
1 - Turn on your computer.
2 - Open the Windows control panel and select the “Add/Remove
Programs” option.
3 - Highlight the “TacT-2.2X” option and click on “Change/Remove”.
4 - Select “Yes” and the old 2.2X software will be removed.
NOTE:Your target curves and measurements stored under unique names
will NOT be removed.
1 - Connect the PC to the RCS2.2X using the RS232 cable. Please refer tothe
RCS 2.2X RS232 section of the user’s manual or the RS232 Connection document
for help.
CAUTION: The RCS-2.2 X should be the only device connected to the RS232
cable during system reprogramming. Please disconnect any TacT digital
amplifiers that may be daisy chained to the RCS-2.2 X.
Update the RCS-2.2 X Firmware
Step I:
Removing your old
RCS2.2X Software
Step III:
Reprogramming the
RCS2.2X Firmware
4 - Turn the RCS-2.2 X OFF from the rear panel mains switch.
3 - Use the “Communication” option in the Tact-2.0 S room correction software to
make sure that the RCS-2.2 X and your computer are communicating. Please refer
to the RCS 2.2X RS232 section of the user’s manual or the RS232
Connection document for help.
Your RCS-2.2 X has been pre-programmed with the latest firmware when shipped
from our factory and does not need to updated with the program CD that came with
your unit. TacT Audio may occasionally release updated versions of the RCS
software that will be available on our website “www.tactaudio.com”. This new
software may contain updates or enhancements for your RCS-2.2 X. When
instructed by a technician or messaged from our website please follow the
instruction below to update your RCS-2.2 X firmware.
2 - Start the TacT-2.2X RCS software on your computer
Step II:
Install your new
RCS2.2X Software
- Double-click on the “Tact 2.2X vx.x.exe” file that you have downloaded or is
found on the root of your CD and follow the installation instructions.
You now need to install the new TacT-2.2X RCS software on your computer.
Program the new firmware for the RCS-2.2 X.
First un-install the current version of the TacT-2.2X RCS software on your computer.