Filter
Top Products
CAUTIONCAUTION
36 Tact Audio
STEP I
Select the speaker configuration setting that you have set for the RCS 2.2x
Operating Mode. This setting is found in the "MODE" menu on the front panel of the
RCS-2.2 X.
Select:
2.2 operating mode - If your system uses two main loudspeakers and two
subwoofers.
2.1 operating mode - If your system uses two main loudspeakers and one
subwoofer.
2.0 operating mode - If your system uses only two main loudspeakers.
You will then need to set the Loudspeaker Crossover Frequency or Loudspeaker
Lower Cutoff frequency. Your Operating Mode selection will determine what
parameters will need to be set. Your subwoofer and main loudspeaker frequency
response will determine the settings needed for these parameters. Please refer to
your main loudspeaker and /or subwoofer manual for this information.
- If you have selected 2.2 or the 2.1 operating mode you will need to set the:
Loudspeaker crossover frequency (this sets the lowest frequency that will be
sent to your loudspeakers.)
Subwoofer lower cutoff frequency (this is the lowest frequency that your
subwoofer can reproduce)
Quick Setup