Filter
Top Products
47 Setting up
FM ANT - aerial input
The K6 features a 75 Ohm VHF aerial input (domestic
aerial or cable).
STB
(SCART
1)
)
Socket for connecting a set-top box (SAT or cable re-
ceiver) with SCART connection
1)
.
MAINS FUSE
It is essential to use a replacement fuse rated exactly as
printed on the case.
MAINS INPUT
The mains cable is connected to this socket. When con-
necting the unit to the mains it is essential to read and
observe the notes in the sections 'Setting up, using the
K6 for the first time' and 'Safety Notes'.
TV
(SCART
1)
)
Input / output socket for connecting a TV set with SCART
connector.
VCR / TV B
(SCART
1)
)
Socket for connecting a video recorder.
Alternatively: connection for a TV set in an adjacent
room.
AUX AV
(STEREO CINCH and VIDEO)
Input for connecting an additional AV source device.
1)
Note
If your AV device does not feature a SCART socket, use
a SCART adaptor cable connected to the VIDEO (Cinch)
or S-VIDEO (Hosiden) input / output socket of your AV
device. Ask your specialist
dealer for advice if you
are not sure.
A - FRONT
Terminals for front loudspeakers
2)
B
Terminals for loudspeakers in adjacent room
2)
PRE OUT
(CONTROL)
Connection for
active loudspeakers, to be used as
front speakers in the main listening room.
Note
This socket also supplies a switching signal which can
be used to activate other devices (e.g. projectors, pro-
jection screens etc.) automatically via the K6 (see 'Ap-
pendix B').
A - REAR
Terminals for surround loudspeakers
2)
A - CENTER
Terminals for center loudspeaker
2)
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be con-
nected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool such
as a knife blade.
2)
Notes
The impedance of the loudspeakers connected to the K6
should not be less than 4 Ω
ΩΩ
Ω (DIN rating).
It is essential to check that the screw terminals are firmly
tightened, and that there are no stray strands of cable
which could cause a short-circuit.
The terminals also feature cross-holes into which standard
insulated 'banana plugs' (4mm) can be fitted from the
underside.
The
accessory range includes a selection of high-
quality cables which are an exact match to
equip-
ment.