Filter
Top Products
56
Operating the MD Recorder Using a Keyboard
Naming a Track or MD Using
the Keyboard
You can easily enter or edit names.
Short cut to the naming procedure
1 To give a name to a track or MD, do the following.
• To name a track
Press Num Lock while the desired track number is
displayed and the recorder is stopped, playing,
paused or recording.
• To name a MD
Press Num Lock when no track number is displayed
and the recorder is stopped.
A flashing cursor appears in the display, and the
characters can be entered.
2 Enter the name
For more on editing during entry, refer to the chart
below.
3 Press the Enter key or Num Lock key
The disc or track name is displayed from its beginning.
Operations you may wish to do while naming a
track or MD
To Press
Cancel the operation [Esc]
Switch between uppercase and [Caps Lock] (or hold
lowercase letters down [Shift]* while
entering letters for
uppercase)
Move the cursor [←] or [→]
Erase the character at the cursor [Delete]
position
Erase the character preceding [Back Space]
the cursor
* If you have assigned characters to keys using [Shift] (see page 58), the
characters you assigned have priority.
z Undoing the naming of a track or MD
1 Press [F11]
“Name Undo?” appears.
2 Press [Enter].
Press [Esc] to cancel the operation.
Using the Edit Menu
1 Do the following to name a track or MD.
• To name a track or MD
Press [Esc] while the recorder is stopped, playing or
paused.
• To name a track during recording.
Press [Esc} during recording.
“Edit Menu” appears in the display.
2 Press [↑]/[↓] or [Tab]/[Shift]+[Tab] repeatedly until
“Name?” appears, then press [Enter].
While the recorder is recording, a flashing cursor
appears in the display, and you can enter a name for
the track being recorded. In this case, please go to step
5.
3 Press [↑]/[↓] or [Tab]/[Shift]+[Tab] repeatedly until
“Nm In?” appears, then press [Enter].
4 Press [↑]/[↓] or [Tab]/[Shift]+[Tab] repeatedly until
the track number (when naming a track) appears or
“Disc” (when naming the MD) flashes, then press
[Enter].
Characters can be entered.
5 Enter the name.
6 Press [Enter] or [Num Lock].
“Complete!” appears for a few seconds, and the
naming is completed.