Filter
Top Products
35
Playing MDs
If you entered the wrong track number
Press m repeatedly until the wrong track number
appears and turn AMS (or press ./> ) to enter a
correct track number. Press CLEAR to erase the track
order so that the track order is moved up.
To enter a track number over 26
Use >25. For details, see page 29.
4 Repeat step 3 to store the track you want to access.
5 Press YES.
“Complete!” appears and the track order and track
number to be stored are completed.
6 Turn AMS (or press ./> repeatedly) to select
“Play Mode” of “Setup Menu” then press AMS or
YES.
7 Turn AMS (or press ./> repeatedly) to select
“M.Access” then press AMS or YES. (Press
M.ACCESS after step 5 for the remote.)
“M.Access” and “1” (Single Play) light up and
“Memorizing” (during recording) flashes, then the
normal screen is returned.
Memorizing
M.ACCESS
1
Note
If the MD is inserted when Multi-access Play is selected,
“Memorizing” flashes and track numbers 1 to 10 in the
track order are recorded and programmed automatically.
To stop “Memorizing”
Press x (stop) when “Memorizing” is flashing.
“Memorizing” stops and “Play Mode” returns to normal
play (CONTINUE).
Multi-access play Z
Press the Number buttons on the remote you want to play
the track order.
z
To play by the recorder
Turn AMS to select the track order, then press AMS.
To resume normal play
While the recorder is stopped, press CONTINUE on the
remote. “M.Access” and “1” at the display window turn
off.
z
The program is stored until the MD is ejected
If the play is stopped or Play Mode is changed and
“M.Access” turns off, the program is stored. If the
multi-access is selected again, “Memorizing” flashes
and the entered program is stored in memory.
Notes
• If the MD is ejected, the program will be lost.
• “ProgramFull” appears when you try to program 11 th
track.
• The set program will be lost when you try record or edit
operation.
Checking the program
1 While the recorder is stopped, press MENU/NO
twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“M.Access?” then press AMS or YES.
3 Press m/M repeatedly for checking.
4 Press MENU/NO to return normal display.
Changing the contents of the program
Do steps 1 to 2 of “Checking the program” and follow the
procedures below.
To Do the following:
Erase a track Press m/M repeatedly until the
number of the unwanted track
appears, then press CLEAR.
Erase all tracks Press CLEAR repeatedly until all the
track numbers disappear.
Add a track to the Press M repeatedly until the track
end of the program order in which “0” flashes, then do
step 3 of “Programming access play
tracks” on page 34.
If 10 tracks are programmed,
“ProgramFull” appears and no
addition is made.
Replace a track Press m/M repeatedly until the
changed track order appears, then do
step 3 of “Programming access play
tracks” on page 34.