Filter
Top Products
23
Recording on MDs
Marking Track Numbers
While Recording
(Track Marking)
You can mark track numbers either manually or
automatically while recording. By marking track numbers
at specific points, you can quickly locate the points later or
edit the MD easily.
AMS
MENU/NO YES
Marking track numbers manually (Manual
Track Marking)
Press z at the point where you want to add a track
number while recording.
Marking track numbers automatically
(Automatic Track Marking)
When recording from a CD player or MD recorder
connected to the DIGITAL IN connector, the recorder
marks track numbers in the same sequence as the source.
When recording from other sources connected to the
DIGITAL IN connector or a source connected to the
ANALOG IN jacks, do the procedure below to mark track
numbers automatically. However, if you hear much noise
from the sources of tapes or radios, the recorder cannot
mark track numbers.
1 While the recorder is stopped, press MENU/NO
twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) until “Track
Mark” appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select
the setting, then press AMS or YES.
Automatic tracking marking Select
Turned on at input level Level Sync
Turned on at the interval Interval
of the fixed time
Turned off Off
4 Press MENU/NO.
To set the level of input signals for Automatic
Track Marking of “Level Sync”
The recorder marks a track number whenever the input of
a signal at the set level or below continues for at least 1.5
seconds and a signal at the set level or above is also input.
1 While the recorder is stopped, press MENU/NO
twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) until “Tr
Mark Level” appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select
the level at any value from a range of _72 dB, _68
dB, _60 dB, _54 dB, and _48 dB, then press AMS or
YES.
4 Press MENU/NO.
To set the interval time of Automatic Track
Marking
The recorder marks a track number at intervals at the set
time.
1 While the recorder is stopped, press MENU/NO
twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) until
“Interval” appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select
the time at any value from a range of 1 minute to
10 minutes, then press AMS or YES.
Note
When the track number of program sources (CD or MD)
changes, a track number changes automatically, or you
want to change the track number by z (REC), the recorder
marks a track number at the interval of the fixed time from
the beginning of the changed track number.
z
Additional information on Automatic Track Marking
• When recording from a CD player or MD recorder
connected to the DIGITAL IN connector, the entire
material may be recorded as a single track in the
following cases:
- When you consecutively record the same track two or
more times using single-track repeat play.
- When you consecutively record two or more tracks
with the same track number but from different CDs or
MDs.
- When you record tracks from certain CD or multi-disc
players.
In either case, divide tracks after recording (page 45).
• If the source is an MD, a track number may not be
marked for tracks less than 4 seconds long (during
stereo, LP2 stereo, or monaural recording) or less than 8
seconds (during LP4 stereo recording).