Filter
Top Products
Chapter 3 Recording and Playback
Chapter 3 Recording and Playback 59
Synchronous Playback
Connecting two DSR-2000/2000P units and synchronizing their tape
transport, you can carry out two-unit synchronous playback with an
accuracy of ±0 frame.
For equipment/signal connections and basic settings, see the section
“Connections for Two-Unit Synchronous Playback” (page 132).
Use the following procedure.
(In the following, the controlling unit is referred to as the recorder (this
unit) and the controlled unit as the player.)
1 Press the PLAYER button, turning it on.
2 Cue up to the player tape position where to start playback.
3 Hold down the ENTRY/SHIFT button, and press the IN button.
The player IN point is set.
4 Press the RECORDER button, turning it on.
5 Cue up to the recorder tape position where to start synchronous
playback.
6 Hold down the ENTRY/SHIFT button, and press the IN button.
The recorder IN point is set.
2,5
4
3,67
1
(Continued)