Filter
Top Products
Chapter 6 Setup Menu
Chapter 6 Setup Menu 121
Item number Item name Settings
801 DIGITAL JOG
SOUND
Select whether to adjust the audio playback speed during slow playback.
OFF: Do not adjust the audio playback speed.
ON : Adjust the audio playback speed.
Menu items in the 800s, relating to audio control
Item number Item name Settings
Menu items in the 700s, relating to video control (continued)
729 CLOSED
CAPTION BLANK
(DSR-2000 only)
Select whether to mute the closed caption signal to be superimposed on the 1st and
2nd fields of the output video signal.
Sub-item
FIELD 1
1
2 FIELD 2
Select whether to mute the closed caption signal to be superimposed on the 1st field of
the output video signal.
OFF : Do not mute.
ON: Mute.
Select whether to mute the closed caption signal to be superimposed on the 2nd field of
the output video signal.
OFF : Do not mute.
ON: Mute.
802 DIGITAL AUDIO
MUTE IN
SHUTTLE MODE
Set the audio muting conditions during shuttle playback.
OFF : Not muted.
CUEUP: Muted during cue-up or preroll operations.
FULL: Muted in shuttle mode.
807 AUDIO OUTPUT
PHASE
Select the output timing of an audio playback signal. The reference position corresponds
to a setting of 80H; when the setting is less than 80H, the output timing is advanced,
and when it is higher than 80H, the output timing is delayed. (80H = 128 samples =
approx. 2.7 ms, 1 sample = approx. 20 µs)
0 ... 80 ... FF : Setting in this range.
808
INTERNAL AUDIO
SIGNAL
GENERATOR
Select the operation of the internal audio test signal generator.
SILNC: Silent signal.
1KHZ : 1-kHz, –20 dB FS sine wave signal.
When you select SG as the audio input in the input selection section of the upper control
panel, the audio test signal generated by the internal audio test signal generator is input.
811 AUDIO
REFERENCE
LEVEL
Select the audio reference level (headroom) for recording on tape.
–12dB
–16dB
–18dB (factory default for DSR-2000P)
–20dB (factory default for DSR-2000)
Note
When you make settings for items 715 to 720, set the
PROCESS CONTROL switch on the subsidiary
control panel to MENU. When it is set to MENU, all
controls on the subsidiary control panel are disabled.
(Continued)