Filter
Top Products
Chapter 8 Maintenance and Troubleshooting
Chapter 8 Maintenance and Troubleshooting 139
Error Messages
This unit is provided with a self-diagnostic function
that detects internal abnormalities. When it detects an
abnormality, it outputs an error message to the monitor
connected to the unit and indicates an error code in the
display section of the unit.
Note
To display error messages on the monitor screen, set
the CHARACTER switch on the subsidiary control
panel to ON.
Error02-603
ERROR
AN ERROR HAS BEEN
DETECTED. INFORM SERVICE
OF FOLLOWING CODE:
02-603
PRESS EJECT KEY
TO EJECT TAPE.
Error code
Error message
Error code
Direction
Monitor screen Display section
An alarm message , for example, like the one shown
below may appear on the monitor screen during
operation of the unit.
REMOTE!
ALARM
REMOTE MODE IS SELECTED
SET REMOTE/LOCAL SWITCH
TO LOCAL
Cause of alarm
Direction
Monitor screen Display section
If an alarm message appears, follow the direction
indicated under the message on the monitor screen.
To display alarm messages on the monitor screen, set
the CHARACTER switch on the subsidiary control
panel to ON, and setup menu item 016 (ALARM) to
ON or LIMIT.
For details of setup menu operations, see Chapter 6 “Setup
Menu” (page 107).
If an error message appears, follow the direction
indicated under the message on the monitor screen.
Alarm Messages