Filter
Top Products
Location and Function of Parts
Chapter 1 Overview
32 Chapter 1 Overview
2 AUDIO IN LEVEL/600Ω switches
Set these switches for each channel as shown in the
following table, according to the audio input levels to
the AUDIO IN CH-1 to CH-4 connectors and the
impedance.
Settings of the AUDIO IN LEVEL/600Ω switches
3 MONITOR AUDIO connector (RCA phono
jack)
This connector outputs audio signals for monitoring.
The audio signals to be output from this connector can
be selected with the MONITOR SELECT buttons on
the lower control panel.
4 AUDIO IN CH-1 (channel 1) to CH-4 connectors
(XLR 3-pin, female)
Use these connectors to connect separate channels of
audio input from a player VCR or other external audio
equipment.
5 AUDIO OUT CH-1 (channel 1) to CH-4
connectors (XLR 3-pin, male)
These connectors output channel-1 to channel-4 audio
signals, respectively.
In 2-channel audio recording mode (selected with
extended menu item 818), it is possible to use the
AUDIO OUT CH-3 and AUDIO OUT CH-4
connectors for monitor audio output for channels 1 and
2, respectively (use extended menu item 820).
Audio input
Switch setting
Level Impedance
−60dBs
(microphone input)
High impedance
(about 20kΩ)
LOW-OFF
(left position)
+4dBs/0dBs/−6dBs
(line audio input)
High impedance
(about 20kΩ)
HIGH-OFF
(middle position)
+4dBm/0dBm/−6dBm
(line audio input)
600Ω HIGH-ON
(right position)