Filter
Top Products
Chapter 3 Recording and Playback
56 Chapter 3 Recording and Playback
Storing a varying playback speed in memory
To store the playback speed for DMC playback, use the following
procedure.
1 Press the DMC EDIT button, turning it on.
2 Either while playing back the recorded tape, or during recording, press
the ENTRY button and each of the following buttons simultaneously,
to set the start and end points.
• On-air start point: AUDIO IN button
• Speed variation start point: IN button
• Speed variation end point: OUT button
• On-air end point: AUDIO OUT button
Each press turns the corresponding button on.
3 Press the SEARCH button or search dial so that the SHUTTLE
indicator in the display section is lit.
4 If you want to use the variable mode to set the varying playback speed,
press the VAIRABLE button, turning it on.
5 Holding down the DMC EDIT button, turn the search dial, to set the
initial speed at the speed variation start point.
The speed you set appears in the display section. During this period the
tape does not move.
6 Press the PREVIEW button.
The tape is prerolled and played back at normal speed from the on-air
start point to the speed variation start point. On passing the speed
variation start point, the MEMORY indicator begins to flash, and
playback begins at the speed set in step 5.
MEMORY indicator
3,5,7
43
261,5 8
Display section
Playback