Filter
Top Products
88
You can implement necessary operation from among them.
REMOVE LINK: Removes logically the HDD link.
HDD FORMAT: Formats the HDD.
RESTART: Closes the menu, and returns to normal operation.
The menu can also be displayed manually when you need to format HDD, or to remove the logical link.
1. Turn off the power of the recorder once, and turn it on again.
The multi-screen monitor displays a message “SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY”.
2. Press the [STOP] button.
The DISK MENU opens.
3. Select any of REMOVE LINK, HDD FORMAT, or RESTART.
Auto-remove
When no button is pressed for 5 minutes after opening the DISK MENU, The recorder will logically remove the disk that meets
any conditions below.
• An HDD has been categorized in “ * ”, “LOST”, or “ERR”.
• Restart was repeated 3 times due to writing error.
● DISK MENU
8 Disk Menu
The menu appears if the hard disk error is found during
power-up.
The buzzer beeps every 5 seconds, and ERROR indi-
cator turns off.
Press buttons other than [STOP] to mute buzzer beep.
Hard disk status and required operation are shown in the table.
DISK MENU
NO.1:117.95GB
NO.2:117.95GB
REMOVE LINK
→
SET
→
HDD FORMAT
→
SET
→
RESTART
→
SET
→
Hard Disk Status
Operation
Abbreviation Status Required
–
Format, remove link ,or replace HDD
if erred even after formatting.
Note
Abbreviation SYS appears in SYSTEM
LOG when indicating a writing error.
Normal status
Writing error
Same as above.LOST or * status was left for
five minutes.
Replaced HDD has been not format-
ted yet.
FormatAwaiting format
Replaced HDD malfunctions.Replace HDD if erred even after
formatting.
HDD error
Appears only when manually opening
DISK MENU.
Remove HDD to add a new one,
or reconnect.
HDD logically removed
Remove link, or add a new HDD.HDD physically removed
FormatHDD added, and awaiting
format
Capacity
ERR
*
LOST
ADD
REMOVE LINK command has been
previously carried out .
Previous time and this time,
HDD logically removed
–