Filter
Top Products
33
• Simultaneous playback will pause prior to a time
space depending on the recording rate if recording
nears to the playback point.
0.1 FPS: 20 minutes maximum
1 FPS: 2 minutes maximum
7.5 FPS: 15 seconds maximum
15 FPS: 7 seconds maximum
• Actual recording rate even preset to 30 or 15 FPS
may be lessened to 7.5 FPS at worst, while such
busy multi task as playback, remote-access play-
back, remote-access live image, FTP access, multi
split display, video motion detection are carried out
at a time. The status display will indicate as
“*→PLAY” while playing back the images recorded
with a changed rate from the preset.
● Alteration Detection Setup
ALTER DETECT
You can enable or disable the recorder to add alteration-
detection signals in the JPEG data supplied to the network.
The default is OFF.
1. Move the cursor to ALT DET.
2. Select ON or OFF with the JogDial and press the
JogDial.
ON: Detects alterations.
OFF: Does not detect.
Note: When set to ON, the data transmission rate on
the network will slow down.
● Disk End Mode Setup
DISK END MODE
The menu offers the following options at the point where the
available recording space on the disk is used up: [STOP],
[CONTINUE].
1. Move the cursor to DISK END MODE with the [D] or
[C] button.
2. Select the desired mode with the JogDial, and press
the JogDial.
The default is CONTINUE.
STOP: Stops recording until a new mode other than
[STOP] is selected.
CONTINUE: Old data is automatically overwritten from
the disk start.
Note: Remaining capacity will be displayed on the monitor
by turning the JogDial counter-clockwise in recording
mode when STOP is selected.
● Disk End Buzzer DISK END BUZZ
The buzzer can be set up to beep at the point where the
disk is full (remaining space 0 %). The setting is available
only when STOP is set for DISK END MODE.
1. Move the cursor to DISK END BUZZER with the [D] or
[C] button.
2. Rotate the JogDial to select the desired parameter.
The default is ON.
ON: Enables the buzzer beep at the disk end (remain-
ing space 0 %).
OFF: Disables the buzzer beep.
● Play Priority Setup PLAY PRIORITY
This setting places priority on a specific access point for
playing back the image data when access collisions take
place.
1. Move the cursor to PLAY PRIORITY.
2. Select an access point with the JogDial and press the
JogDial.
LOCAL: Places priority on the front panel operations.
NET PLAY: Places priority on the network access.
FTP GET: Places priority on the access to the FTP.
NONE: The latest operation has priority than others.
DISK ENDDISK START
DISK ENDDISK START
DISK ENDDISK START
DISK ENDDISK START
Waiting for a new entry
Overwritten automatically
Stop
REC
Restart
REC
[STOP]
[Default]
[CONTINUE]
SYSTEM SETUP (1 OF 2)
PASSWORD LOCK OFF
ALL
→
*****
OPERATION
→
*****
KEYLOCK BUZZ OFF
SKIP ALM-RECALL 5PAGE
SIMUL REC&PLAY ON
ALTER DETECT OFF
DISK END MODE CONTINUE
DISK END BUZZ ON