Filter
Top Products
38
● Camera Number Setup CAM NO.
SETUP (exclusive for PS
•
DATA)
Camera numbers will be used in a PS
•
DATA chain when
you select the desired camera to control it, operating on a
system controller.
1. Move the cursor to CAM NO. SETUPO with the [D] or
[C] button, and press the JogDial. The CAM NO.
SETUP menu opens.
2. Move the cursor to the desired line with the [D] or [C]
button.
3. Select the number with the JogDial, and press the
JogDial.
The default number is the same as the CAM-PORT
number.
Assignable number: From 001 to 128, each number
must be unique in the chain.
4. Press the [SETUP/ESC] button to go back to the SERI-
AL SETUP.
■ Network Setup NETWORK
SETUP
Note: The system will restart after the menu setup window
is closed when any parameter in this window has been
changed.
● Line Speed LINE SPEED
1. Move the cursor to LINE SPEED with the [D] or [C]
button.
2. Select the parameter with the JogDial, and press the
JogDial.
The default is AUTO.
AUTO: The speed is automatically selected.
100M_FULL: 100 mega byte, full duplex
100M_HALF: 100 mega byte, half duplex
10M_FULL: 10 mega byte, full duplex
100M_HALF: 10 mega byte, half duplex
● HTTP Port HTTP PORT
Set an HTTP port number.
The default is 80.
Available Port Number: From 00000 to 65535
● Host Name HOST NAME
A maximum of 10-digit host name is entered using alphanu-
meric and symbols.
The default is WJ-HD200••.
● Dynamic Host Configuration Protocol
DHCP
Dynamic Host Configuration Protocol is enabled or dis-
abled.
The default is OFF.
Note: When ON is selected, you cannot enter IP
address, netmask, or gateway. The host gives these
parameters.
The given parameters will be displayed after getting
IP address from the DHCP server.
CAM NO.SETUP
CAM-PORT CAM NO.
1 001
2 002
3 003
4 004
5 005
6 006
7 007
8 008
NETWORK SETUP
LINE SPEED AUTO
HTTP PORT
→
00080
HOST NAME
→
WJ-HD200••
DHCP OFF
IP ADDR
→
192.168.000.010
NETMASK
→
255.255.255.000
GATEWAY
→
192.168.000.001