Filter
Top Products
4 - 3 4 - 3
MELSEC-GOT
4 MONITORING SPECIFICATION
Monitor (write from GOT) for remote input and remote register (read area)
RX
RWr
Master
station
PLC CPU
RX
RWr
2)
3)
2)
3)
GOT
Line1
Line2
Line3
100
0
50
400
100
FROM
1) The data is stored in the GOT's remote input
(RX) and remote register (RWr).
(Touch switch function, numeric value input function,etc.)
2
) By link scan, the data is stored in the remote input
and remote register allocated to the master station GOT.
(Collected for each link scan.)
3
) Remote input and remote register data are read to
the PLC CPU.
The monitor point vary depending on the number of
occupied stations setting.
When 2 stations are set
RYn0 to RY(n+2)F:48 points
RWrm to RWrm+7:8 points
When 4 stations are set
RYn0 to RY(n+6)F:112 points
RWrm to RWrm+F:16 points
POINT
The GOT can input (e.g. touch key function) data to only the remote inputs (RX)
and remote registers (RWr) assigned the master station.
It cannot input (e.g. touch key function) or display (e.g. lamp display function) data
to the other remote inputs (RX) and remote registers (RWr).