Filter
Top Products
3 - 1 3 - 1
MELSEC-GOT
3 SPECIFICATIONS
3. SPECIFICATIONS
This chapter provides the general and performance specifications and other
information of the A8GT-J61BT15.
3.1 General Specifications
The general specifications of the A8GT-J61BT15 changes according to the GOT used.
Refer to the user's manual of the GOT used.
3.2 Performance Specifications
The following table lists the performance specifications of the A8GT-J61BT15.
Item Specifications
CC-Link station type Remote device station
Number of stations occupied
May be selected between 2 and 4.
2 station: RX/RY 64 points each
1, RW write area 8 points each/read area all area
4 stations: RX/RY 128 points each
1, RW write area 16 points each /read area all area
Monitor device
Write from GOT:RX,RWs assigned to the GOT (depending on the number of stations occupied(Refer
to upper))
Resd to GOT : RX,RWs assigned to the GOT (depending on the number of stations
occupied(Refer to upper))
Transmission speed 156kbps/625kbps/2.5Mbps/5Mbps/10Mbps
Max. transmission distance Depends on the transmission speed.
Max. number of modules
connected
32 (when two stations are selected)
The max. number of modules connected depends on the configuration of the CC-Link system to be used.
For more details on the max. number of modules connected, refer to the CC-Link System Master-
Local Module User’s Manual.
Connection cable CC-Link dedicated cable
Terminal block 8-pin terminal block (M3.5 8 screws)
Applicable cable size 0.75mm
2
to 2.00mm
2
Applicable crimping terminal RAV1.25-3, RAV2-3.5 (conforming to JIS C2805)
Current consumption 100mA
Outline dimensions 99mm(3.9inch)(H) 149mm(5.85inch)(W) 34mm(1.34 inch)(D)
Weight 0.20kg (0.44lb)
Compatible software package
2
GOT-A900 Series
SW0D5C-GTWORKS-E Version A or later
SW0D5C-GOTRE-PACK Version A or later
GOT800 Series
SW3NIW-A8GOTP Version A or later
SW3NIW-A8SYSP Version A or later
SW3NIW-A8GMDP
1 Each of the I/O signals (RX, RY) occupies 16 points of a system area within device points.
For more details on the I/O signals, refer to Section 4.3.1.
2 Be sure to use a software package that supports the GOT to be used.
For more information on the software packages that support the GOT, refer to the user’s manual of the GOT to be used.
3