Filter
Top Products
4•18 User Guide
TRANSPOSING THE TRACKS (BY
SEMITONES)
The Preset tracks can be individually transposed
in semitone steps using the “Section Transposer”
function in «Edit Preset».
The range over which a section can be trans-
posed is ± 24 semitones (2 octaves) and the set-
tings can be stored to the Preset.
1. Press PRESET in the EDIT section.
2. Press PAGE+/BANK+ to enter the SECTION
TRANSPOSER on page 2.
3. Select the track that requires transposing using
the Function buttons.
4. Rotate the Dial to set the required transposition
(+ value = transpose UP, - value = trans-
pose DOWN).
Instead of using the DIAL, you can change
the track transpose setting by means of the
corresponding sliders (F1…F8). The bottom
LED of the sliders turns on to indicate that
they are enabled as data entry controls. If
you use the sliders, it is not necessary to se-
lect the tracks first.
5. Escape «Edit Preset» by pressing ESCAPE.
To save the transposition settings, save the Pre-
set using STORE PRESET.
Transposing Tracks
PRESET
1/2
PAGE+ / BANK+
PAGE– / BANK–
F1 F2 F3 F4 F5 F6 F7 F8
3
4
5
ENTER ESCAPE
2/9 PRESET:TRANSPOSER [Tk07]
00 00 00 00 00 00 +04 00
MAX
MIN
DRUMS
ACCOMPANIMENT
BASS ACCOMP.1 ACCOMP.2 ACCOMP. 3 LOWER UPPER 2 UPPER 1
F1 F2 F3 F4 F5 F6 F7 F8
OR