IBM PS1500 Stereo Amplifier User Manual


 
Styles 5•13
CHANGING THE SPLIT POINT
The Split Point is:
a) the point that separates the Upper and Lower
keyboard sections in Style/Preset mode and,
b) the point below which the keyboard recog-
nizes chords which trigger the Style automatic
accompaniments (in One Finger and Fin-
gered chord recognition modes).
The current Split Point setting can be viewed in
the MODE/SPLIT POINT display by holding
pressed the EASY PLAY button for about 2 sec-
onds. The setting can be modified as required.
1. Press and hold EASY PLAY/SPLIT to open the op-
tion page.
2. Press Function button F7 or F8 to activate the
Split Point function.
3. Rotate the DIAL or play a note on the keyboard
(corresponding to the highest note of the Lower
split zone) to modify the setting.
The new Split Point is shown in the display.
If you entered the wrong note, simply play
another.
4. Press ENTER to confirm the new Split Point and
close the display. Press ESCAPE if you want to
cancel the operation (and retain the original set-
ting).
Note: The Split Point is a general parameter
(not linked to a particular Preset) which is
conserved in memory when the instrument is
turned off. The new setting is lost when the
“Restore Original Block” operation is carried out or
if the back-up memory loses its data due to the
total discharge of the battery.
Changing the Split Point
1
EASY PLAY
SPLIT
1/1 MODE/SPLIT POINT:
Mode=Full Split Point=F#3
2
F1 F2 F3 F4 F5 F6 F7 F8
1/1 MODE/SPLIT POINT: [PRESS ENTER]
Mode=Full Split Point=F#3
3
4
ENTER ESCAPE
OR