Filter
Top Products
10-6 Recovering Your Data
NOTE: If Disaster Recovery Disc #1 is not in your HP CD-Writer Plus, you will
be prompted to insert it at this time.
Disaster Recovery will begin recovering the Windows File System.
10. Once the volume has been recovered, a summary of the process will be
displayed. To exit this screen, press
Enter. If there is more than one
volume to be recovered, you may select it at this time.
After recovering the volume(s), you may wish to view the REPORT.TXT
file which contains a text summary of the files that could not be
recovered. If you wish to view this file, you must first exit the program by
pressing the
Esc key twice, then typing EDIT REPORT.TXT. After
reading the text, press
Alt+F, then press X to exit the editor.
Your recovery is complete. Remove any diskettes and discs from your
machine and restart your computer.
NOTE: It may be necessary to restart your computer more than once if any
hardware in your system has changed since your DR Set was created.
For Windows NT
A minimal install of the Windows NT Workstation will be performed
from the Disaster Recovery Set.
HP Disaster Recovery screens will display messages instructing you when
to insert each of the four diskettes from your Disaster Recovery Set.
To recover your data:
1. Insert the Windows NT Workstation Setup Boot Disk (diskette #1 of the
DR Set) and restart your computer. You will be guided through a partial
NT installation.
Only the boot drive and the NT installation drive need to be partitioned
at this time. You will be able to partition and format other drives at a
later time through the Disk Administrator in the HP Disaster Recovery
process.
2. Restart your computer when prompted.
The DR Wizard should appear now and guide you through the steps
necessary to recover your system.