Filter
Top Products
Quick Start Instructions
5
Signature 2.0
DIGITAL AUDIO DATA INPUTS
ANTENNA
SUB
1 2 3 4 5 6SURRCENTER SURRCENTERFRONT
1 2 3 4
65
32
RS-232
115V
~
60Hz
75 WATTS
IR
IN
IR
OUT
TRIGGER
OUTPUT
FM AM
ANALOG AUDIO INPUTS
AUDIO OUTPUTS
REC OUTPUTS6-CH DIRECT INPUTS
EXTERNAL CONTROLS
L
R
L
R
FRONT
1
1
Manufactured under license from Dolby Laboratories Licensing
Corporation. "Dolby", "AC-3", "Pro Logic" and the Double-D symbol
are trademarks of Dolby Laboratories Licensing Corporation.
Copyright 1992 Dolby Laboratories, Inc. All rights reserved.
SERIAL NUMBER
MODEL NO.: SIGNATURE SERIES 2.0
HARMAN KARDON
NORTHRIDGE
CALIFORNIA, USA
MADE IN USA
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTIONCAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
OUT
MAIN
OUT
IN
MAIN
4
5 6
2
S – VIDEO
COMPOSITE VIDEO
REC
REC
SUB
IN
®
NRTL /C
LR110480
CSA E65
Connect to output
of composite
video sources
Connect 75-ohm
FM antenna here
Connect AM loop
antenna here
Connect to coaxial
digital audio output
of A/V sources, DVD,
HDTV, CD, etc.
Connect to optical
digital audio output
of A/V sources, DVD,
HDTV, CD, etc.
Connect to
composite
video input of
main monitor
Connect to
composite
video input
of VCRs
Connect to
S-Video input
of main monitor
Connect to
S-Video input
of VCRs
Connect to analog audio
output of A/V sources,
CD, tuner, etc.
Connect to audio
input of VCR or
audio recorders
Connect to
a powered
subwoofer
or subwoofer
amplifier
Connect to
inputs of audio
power amplifiers
Connect to "Trigger
In" jack on Signature
Series or other compatible
power amplifier
Connect AC Power
to non-switched
wall outlet
Connect to
S-Video
output
sources
Quick Start Connection and Setup
Remote
Button
TV
Video 1
Video 2
Video 3
Tuner
CD
Tape
Aux
Source
Equipment
Cable Box, Satellite
Receiver, TV Tuner
VCR
DVD
HDTV, Satellite with Digital
Audio, Laser Disc
Tuner (internal)
CD Player
Cassette or Tape Deck
Outboard Decoder
Video Input
Connection
Analog 2
Analog 1
Digital 1
Digital 2
(Internal Tuner)
Digital 3
Analog 5
6-Ch. Direct Inputs
Audio Input
Connection
Composite 2
Composite 1
S-Video 1
S-Video 2
Composite 2
N/A
N/A
Composite 1
1. Before proceeding, make certain that all equipment, including the 2.0, is unplugged from AC power. This will prevent
any damage due to the unintended activation of automatic turn-on circuits.
2. Use high-quality audio and video interconnect cables to connect your source equipment to the rear of the 2.0 as shown
in the diagram above and the table below. It is important to note that unlike conventional audio/video equipment, the 2.0
does not have inputs that are labeled for connection to a specific type of equipment (e.g., inputs labeled “CD,” “Tape” or
“VCR”). Instead, the 2.0 allows you to connect the analog or digital audio and composite or S-Video outputs of your source
equipment to any of the inputs. Then, using the setup procedures detailed on page 28 of this manual, you can custom
configure the input sources. However, for a quick starting point, follow the input suggestions outlined in the chart shown
below. They conform to the preset conditions for the 2.0.