Filter
Top Products
Operation
38
Signature 2.0
to transfer the codes from your TV’s remote to the 2.0
remote. Remember that in the factory default con-
figuration, the
TV Volume
buttons
q
operate only
when the
TV Source
button
g
has been pressed. To
program the codes for use when other inputs are active,
follow the instruction on page 17.
Note that the front panel volume control is electronic,
unlike the traditional mechanical potentiometer volume
controls on most conventional audio equipment.
Electronic volume controls require more than one
rotation to go from complete silence to maximum
volume level, and there is no fixed start or stop point.
As the volume control is changed a visual indicator will
appear on screen (Figure OSD-13) to provide a visual
reference of the volume level. Volume changes will also
be shown on the front panel display (Figure FPD-8).
Figure OSD-13
Figure FPD-8
The relative volume setting may be viewed whenever
the front panel display is turned on by looking at the
right side of the front panel
Information Display )
(Figure FPD-4). It may also be viewed as part of the dis-
play that is part of the status message (Figure OSD-14)
that appears when the
Display
button
x
is pressed.
Volume 23
< >
....
Volume 23
Figure OSD-14
During a listening session it may occasionally be
necessary to quickly lower the volume to answer the
phone or for some other reason. This is easily done by
pressing the
Mute
button
8 s
on either the front
panel or remote. When either Mute button is pressed the
output to all speakers will be interrupted, although the
signal to the record outputs will remain active.
When the Mute function is engaged a message will
appear in both the On-Screen Display (Figure OSD-15)
and in the front panel
Information Display
(Figure FPD-9).
Figure OSD-15
Figure FPD-9
To return to normal listening press the
Mute
button
8
s
on either the front panel or remote, or raise or lower
the volume using the front panel or remote
Volume
controls
9 r
.
Video 1 Mute
Dolb
y
ProLo
g
ic
Mute
Video 1 Vol
Dolby ProLogic 10
No AC-3 Info