Filter
Top Products
Operation
39
Signature 2.0
Source Selection
After turn on/off and volume, the most frequently used
controls on any audio video product are the input source
selectors. The current input source is always displayed
in the front panel
Information Display
(Figure FPD-4)
and may be shown on screen (Figure OSD-14) when the
Display
button
x
is pressed.
To change the input source, press the
Source
⁄
or
Source¤
buttons
3
on the front panel or the
individual direct access
Source Selection
buttons
g
on the remote.
When you change a source you are not only changing
the input signal sources, but all of the other parameters
associated with the source profile. Thus, when a source
changes you may also be changing the surround mode,
effects parameters, channel balance and active channel
locations. When the 2.0 is first turned on, the source pro-
files are set to the defaults listed on page 6. To customize
the profile of a specific input source, follow the instruc-
tions shown on page 27 of the Manual.
When the input source profile is changed, the message in
the front panel
Information Display )
will change
and display the new source name, processing mode and
current volume level (Figure FPD-4). A message with the
source name and surround mode will also appear briefly
through the On-Screen Display System (Figure OSD-16).
Figure OSD-16
DVD Vol
Dolby Digital 10
If the source selected is the tuner, the front panel display
will first show the source name and mode (Figure FPD-
10), and will then switch to a readout of the frequency
being tuned, preset memory location, if any, and volume
level (Figure FPD-11). Selecting the Tuner when the on-
screen display is activated will also show the frequency
and preset memory location, if any (Figure OSD-17).
Figure FPD-10
Figure FPD-11
Figure OSD-17
NOTE: While the switch from one input source
profile to another is usually instantaneous, a large
number of complex calculations are made by the 2.0’s
microprocessors to switch the surround processing
modes and other operating parameters. For that reason,
you may occasionally encounter a very slight delay
when pressing a new source button before the mode is
changed. This is normal and does not indicate any
problem with the unit.
Tuner PSet: 01
Stereo 90.7 FM
NO VIDEO PRESENT
01 90.7 FM
.
Vol
10
Tuner
.
Vol
Stereo 10