Harman-Kardon HA160-0004-A Stereo Amplifier User Manual


 
Front Panel Controls
9
Signature 2.0
7 Tune Buttons:
Press these buttons when the tuner
is the input source to select the station being listened to
from the frequencies previously entered into the preset
memories.
8 Mute Button:
Press this button to temporarily
silence the audio output. Press the button again, or
change the volume level to return to normal operation.
Note that when the Mute function is activated, the feed
to any recorders connected to the
Record Outputs £
will remain uninterrupted. When Mute is engaged a
reminder message will appear in the on-screen display
(see figure OSD-15 on page 38) and the word
Mute
will replace the volume level in the
Information
Display )
(see figure FPD-9 on page 38).
9 Volume Control:
Turn this knob to the right or
left to raise or lower the volume. This is an electronic
volume control, so unlike the conventional volume
controls you may be used to, it does not have a start or
end point to its rotation. Volume indications are provided
in both the front panel
Information Display )
and the on-screen control system (see figure OSD-13
on page 38) to provide information about the relative
volume setting.
) Information Display:
This two-line display is
your window into the status and operation of the 2.0.
In normal operation it displays the current input source
and surround mode at the left side of the display, and the
volume level on the right side. When the tuner is in use
the top line of the display will show the preset number
and frequency of the station being listened to. Additional
messages will be displayed depending on which input or
mode is in use, including RDS data from the FM tuner,
and abbreviated versions of the on-screen menus used
during installation, setup and configuration.
! Remote Sensor Window:
This area contains the
sensor that receives commands from the Signature 2.0’s
infrared remote control. Make certain that it is not
blocked by cabinets, smoked glass or doors or other
objects that may interfere with the line of sight from
the remote.