Filter
Top Products
Page 86
Page 87
Press the remote’s MENU button to activate the OSD. It should be present even when no video source
has been selected. Remember, there is no OSD “Pop Up” for component video connections.
Sound drops out with CD or DVD playback
Make sure the disc is not dirty or scratched.
Some inexpensive players and changers tend to mistrack more often, causing dropouts with an
external DAC.
Remote Won’t Learn Commands or Codes
See page 45
Make sure you are pointing the original remote into the receiving window of the Emotiva remote. This is
located on the top edge of the remote.
Try touching and holding the rst button to be learned.
Do not do the learn procedure in bright lighting or sunlight.
Make sure the Emotiva remote is correctly in its LEARN mode.
Make sure the batteries in the remote are fully charged.
Try varying the distance between the remotes from 1 to 2 inches, and see if the learn procedure
improves.
Remote Not Working
See pages 43-49
Make sure the batteries are not dead, or installed incorrectly.
Make sure the remote is set on the correct device display for the component you are trying to control.
Make sure that the buttons have not been erased or learned over.
Make sure that the DMC-1 front panel receiver window is not obstructed.
Check that the front or rear IR receivers have not been turned o in the OSD CONTROL menu.
ZONE 2 Not Working
See pages 43 and 55
Zone 2 is set “disabled” from the factory, so you must use the OSD Zone 2 menu on page XX to enable
it when you are ready to use it. This enables Zone 2, but it does not turn it on.
Once Zone 2 is enabled, use the remote control’s Zone 2 device button, followed by the Power button
to turn Zone 2 on. Alternatively, press the front panel Zone 2 button, followed by the main Power
button. The front panel (left hand side) Zone 2 Power light will be on when the zone is active (i.e.
engaged and on). The Zone 2 Adjust light turns on when the zone is being adjusted. For example,
if you turn Zone 2 on with the remote, and adjust the volume, Zone 2’s volume changes, and the
Zone 2 Adjust light will be on.